Rise, Run, Tread, Nosing, and Width of a Stairway - Inspection Gallery - InterNACHI®

Rise, Run, Tread, Nosing, and Width of a Stairway: The tread depth should be at least 10 inches (254 mm). The tread depth is measured horizontally between the vertical planes of the foremost projection of adjacent treads and at a right angle to the tread’s leading edge. The greatest tread depth within any flight of stairs or stairway should not exceed the smallest by more than 3/8 inch (9.5 mm). The riser height is at most 7 and 3/4 inches (196 mm). The riser is measured vertically between leading edges of the adjacent treads. The greatest riser height within any flight of stairs or stairway shall not exceed the smallest by more than 3/8 inch (9.5 mm).

Five Code Requirements You Need to Know for Handrails

Interior > General - Inspection Gallery - InterNACHI®

Stairs - Risers and Treads - Building Codes and Compliance - ChiefTalk Forum

Stair Tread NoseSpecifications Building stair tread nosing codes, hazards & stair fall research

stairs Search Results - Inspection Gallery - InterNACHI®

Inspecting a Deck, Illustrated

Proper Landings-Are your stairs safe?

Renovation Abrasive Stair Tread Nosing

Inspecting Stairways, Railings, and Guards at Commercial Buildings - CCPIA

Interior > General - Inspection Gallery - InterNACHI®

Problems Building Progressively Larger Stair Steps - Building Code Reference Tips

1910.25 - Stairways. Occupational Safety and Health Administration

Exterior step requirements - Exterior Inspections - InterNACHI®️ Forum

JoeKeresztury's blog

Chapter 5: Stairways